Prototype High Clearance Intake Manifold, J30, J32, J35, Jswap, j32a2, Honda For Sale - New and Used

If you want to run your car as a sleeper or simply don\'t want to cut a hole in your hood this is the solution you have been looking for!

The new Prank PartsHigh Clearance Intake Manifold is a limited run of only 6 hand made intake manifolds that gain hood clearance with j series engines. This intake has been tested with Hasport gen 2 mounts in an EG and EK with the mounts all the way up and over half an inch of hood clearance at the lowest point (Not tested on EF). This will also work with gen 1 mounts and some custom made spacers. Designed to use the same throttle body as the J series engines means that any aftermarket throttle body for the D/B/H series engines will fit, photos show a 74mm Blox B series throttle for reference. Includes stainless bolts and brass fittings for vacuum lines.

The manifold comes UNCOATED as mild steel, it is very important that the owner coats the manifold after receiving it to prevent rusting, the PCV will provide oil on the interior so rust will not be a problem inside the intake. Requires a 6mm ball end to reach the rear bolts and may need to be modified.

---