Headlights For 2008-2012 Honda Accord 4-Door Sedan Black Amber Left + Right Lamp
Item 2008 2009 2010 2011 2012 Honda Accord4-Door Sedan
Vehicle Compatibility Reference Number：33100TA0A01 33150TA0A01, HO2502130 HO2503130
REPLACEMENT PART Part Number: Housing Clear Lens with Amber Reflector
Made of material that meet or exceed OEM requirement
Low Beam Bulb Type: 9006 HB4 (bulb not included)
High Beam Bulb Type: 9005 HB3 (bulb not included)
Placement on Vehicle: Front, Left, Right
Type: Halogen Headlights
PACKAGE INCLUDES:
1 Pair Set of Left Driver Side + Right Passenger Side Headlights Headlamps
HOW TO INSTALL:
1.Undo the screws, clips, or retainer springs that hold the headlight in place.
2.Disconnect the wiring from the assembly.
3.Detach the headlight from the vehicle to replace it with a new one.
4.Fit in the new headlight assembly.
5.Fix the new headlight into place and make sure that the screws, clips, or retainer springs used are sealed.
6.Reconnect the wiring that was unplugged from the assembly.
7.Put back the grille and other components that you removed. Seal them back into place.
HOW TO ADJUST:
Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to25 feet from the wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than3.5 feet above the ground.
1. Find the adjustment screws. Firstly, locate the adjustment screws on your vehicle.
2. Adjust the headlights individually. The headlights should be adjusted one at a time. Put a rag or towel over a chair infront of the light you want to block. Covering the light assembly directly can damage the plastic lens.
3. Adjust the vertical field. The screw on the top of the light housing should be turned clockwise to raise the lights andcounterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the lightbeam shines directly on or just below the center of the tape line on the wall.
4. Adjust the horizontal field. The screw on the side of the light housing should be turned to get the right/left adjustmentcorrect. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.
5. Test your results.
More Jun 7, 2023 at 22:56:32 PDT, seller added the following information:
On Aug 25, 2023 at 00:37:41 PDT, seller added the following information:
