Compatibility:1986-1988 Suzuki Samurai 1.3LFeatures:-OE design to ensure exact fit, form and function for an easy drop-in installation;-Built with high density multi-lowered fins for maximum cooling efficiency;-ISO 9001 certified manufacturing plants;-Direct Replacement;-Improve Cooling Efficiency;-100% Leak Tested;-Plastic tanks with aluminum core;-Built to strict quality control standards;How to clean radiator: Aluminum Radiator For 1986 1987 1988 Suzuki Samurai 1.3L New Replacement
Compatibility:
1986-1988 Suzuki Samurai 1.3L
Features:
-OE design to ensure exact fit, form and function for an easy drop-in installation;
-Built with high density multi-lowered fins for maximum cooling efficiency;
-ISO 9001 certified manufacturing plants;
-Direct Replacement;
-Improve Cooling Efficiency;
-100% Leak Tested;
-Plastic tanks with aluminum core;
-Built to strict quality control standards;
How to clean radiator:
1.Start the vehicle, to rise to normal temperature. Slowly open the tank cover, the fluid shake fromthetank after filling the mouth, the cleaner can be mixed with any brand of coolant. Idle running not less than 15 minutes, not cleaning vehicles not less than 30 minutes for two years. And then discharge coolant, flush water tank, until out of clear water, suitable for any water cycle system.
2.After cleaning, after waiting for pipeline rehabilitation add fluid to water tank, and inject new coolant and water purification.
How to replace the radiator:
1.Disconnect the battery.
2.Drain the radiator fluid into a suitable container.
3.Remove the old radiator:
-Take off any plastic covers around the radiator.
-Disconnect the electrical connector to the fan, and unbolt and remove the fan assembly.
-Disconnect the radiator hoses from the radiator.
-Disconnect the transmission cooling lines from the bottom of the radiator.
-Remove any clamps, brackets, or screws holding the radiator inside its frame.
-Lift the radiator up and out of the car.
4.Install the new radiator:
-Slide the new radiator into place.
-Connect any clamps or brackets that hold the radiator in place.
-Connect the transmission cooling lines carefully.
-Connect the engine cooling hoses to the radiator.
-Replace the fan and fan shroud.
-Reconnect the fan electrical connection.
-Replace the plastic covers.
5.Fill the radiator with fluid.
6.Check your work to make sure that there are no leaks.
(Tools need to be prepared: Screwdrivers, Wrenches, Drain pan)
Note: Do please keep children and pets away when replacing the operation, the vehicle normal temperature 60 to 80 degrees.
2.Add detergent if the tank is too full can take some brand new radiator
Item SpecificsBrand ECCPPManufacturer Part Number E164591CPWarranty 1 YearInterchange Part Number CU208,208,Engine Rad,Replacement Radiator,0.63in.Core ThicknessCustom Bundle NoModified Item NoFitment Type Direct ReplacementPlacement on Vehicle FrontType RadiatorMaterial AluminumCore Material AluminumTank Material PlasticQuantity 1PC RadiatorCore Length 14.77in.Core Height 14.49in.Core Thickness 0.63in.Inlet Diameter 1 1/8in.Outlet Diameter 1 1/8in.Other Part Number 8010170,engine radiator,cooling radiator,air radiator,aluminiumSuperseded Part Number Cap As Picture showsStyle DownflowRow Count 1 RowColor Black or SilverNotes Please verify the item fits your vehicle or not by compatibility Item SpecificsBrand ECCPPManufacturer Part Number E164591CPWarranty 1 YearInterchange Part Number CU208,208,Engine Rad,Replacement Radiator,0.63in.Core ThicknessCustom Bundle NoModified Item NoFitment Type Direct ReplacementPlacement on Vehicle FrontType RadiatorMaterial AluminumCore Material AluminumTank Material PlasticQuantity 1PC RadiatorCore Length 14.77in.Core Height 14.49in.Core Thickness 0.63in.Inlet Diameter 1 1/8in.Outlet Diameter 1 1/8in.Other Part Number 8010170,engine radiator,cooling radiator,air radiator,aluminiumSuperseded Part Number Cap As Picture showsStyle DownflowRow Count 1 RowColor Black or SilverNotes Please verify the item fits your vehicle or not by compatibility
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
- PayPalpreferred.
PictureHot Item Pair For 2007-2014 Chevy Silverado Sierra Towing Power Heated LED Signal Mirrors USD 124.69 Pair Manual Adjust Tow Mirrors For 1988-1998 Chevy GMC C K 1500/2500/3500 USD 62.99 Front Wheel Hub Bearing For Chevy Monte Carlo Impala Cadillac Eldorado DTS FWD USD 40.38 Universal 12V Low Pressure 5-9 PSI Electric Fuel Pump Installation Kit E8012S USD 14.15 ECCPP 2 Pcs Wheel Hub Bearing Front For Buick LaCrosse Century Regal Lesabre FWD USD 60.95 Shop CategoryStore Home Air Dryer Car Tools◈Car Tools◈Electric Winch Tow◈Jack Stand◈Jumper Cable◈Removal Tool◈Tire Pressure Gauge Clutch System◈Clutch Slave Cylinder Cooling System◈AC Compressor◈Air Blend Door Actuator◈Blower Motor Resistor◈Condenser◈Coolant Tank◈Cooling Fan◈Evaporator◈Heater Control Valve◈Heater Hose◈Radiator Support◈Thermostat Housing◈Water Pump◈Water Pump Impeller Copper Tube◈ATV Brake Caliper◈ATV Brake Master Cylinder◈Brake caliper◈Brake drum shoe◈Brake lines kit◈Brake rotor pad◈Brake Shoe◈Clutch Lever◈Power Brake Booster Crankshaft And Camshaft◈Camshaft & Crankshaft◈Harmonic Banlancer◈Timing Chain Kit Drive Belt And Device◈Primary Drive Clutch◈Serpentine Belt Tensioner◈Wear Ring Drive Shaft And Half Shaft◈4 Pcs Wheel Hub Bearing◈C Notch & Flip Kit◈CV Axle◈CV Axle Boot◈Driveshaft◈Rear Wheel Axle◈Wheel Hub Bearing◈Wheel Hub Bearing Knuckle◈Wheel Hub Centric Rings◈Wheel Spacers Engine Bracket Glue◈Engine Mount Engine Gasket & Cylinder Head◈Carbon Seal◈Cylinder Head◈Cylinder Piston Gasket Kit◈Head Gasket Set Fuel System◈Car Carburetor◈Fuel Cell Gas Tank◈Fuel Injectors◈Fuel Pump Assembly◈Fuel Tank Pipe & Cap◈Fuel Tank Valve & Regulator◈Mass Air Flow Sensor◈Motorcycle Carburetor & Parts◈Oil Fuel Hose◈Purge Valve◈Vacuum Pump Gas Distribution System◈Diesel Emissions Fluid Pump◈Hydraulic Lifter & Rocker Arms◈Idle Air Control Valve◈Intake Carburetor Boot◈Secondary Air Pump◈Throttle Body◈Turbocharger◈Valve Cover Golf Series Home gardening◈Courtyard And Outdoor Supplies Ignition System◈ATV Ignition Coil◈Fuse Box◈Glow Plugs◈Ignition Coil & Spark Plug◈Ignition Coils◈Ignition Distributor◈Spark Plug Wire Set◈Wiring Harness Inner Parts◈Air Cleaner Box Assembly◈Car Floor Mats◈Car Seat Cover◈Cargo Cover◈Center Console◈Dash Cover & Cushion◈Fastener◈Remote Key◈Shift Knob Lever Head◈Steering Wheel & Adapter◈Sun Visor Lawn Mower Parts Light products◈Exterior Lights◈Fog Light◈Headlight Assembly◈Instrument Panel Lights◈Interior Lights◈Led Headlights◈Motorcycle Light◈Side/Cab Marker Lights◈Special Model Lights◈Third Brake Lights Lubrication System◈Dipstick◈Engine Oil Cooler◈Oil Pan◈Oil Pump Other Parts◈Shackle Kit◈Wheel Lug NutsNew List Item Front For Toyota Camry 1992-01 Solara 1999-01 2 CV Axles & 4 Brake Ceramic Pads USD 168.99 Fit For Dodge Ram 2019-2022 Temp Sensor+BSM Power Heated Outside Mirror Pair Set USD 225.19 Front Ceramic Brake Pads For 2003-2008 Pontiac Vibe Toyota Corolla Toyota Matrix USD 28.72 Power Heated Tow Mirrors For 14-17 Chevy Silverado GMC Sierra 1500 Smoke Signal USD 129.99 Front Drilled & Slotted Ceramic Brake Pads And Rotors For Lexus RX350 Toyota USD 111.55 Aluminum Radiator For 1986 1987 1988 Suzuki Samurai 1.3L New Replacement Compatibility:
1986-1988 Suzuki Samurai 1.3L
Features:
-OE design to ensure exact fit, form and function for an easy drop-in installation;
-Built with high density multi-lowered fins for maximum cooling efficiency;
-ISO 9001 certified manufacturing plants;
-Direct Replacement;
-Improve Cooling Efficiency;
-100% Leak Tested;
-Plastic tanks with aluminum core;
-Built to strict quality control standards;
How to clean radiator:
1.Start the vehicle, to rise to normal temperature. Slowly open the tank cover, the fluid shake fromthetank after filling the mouth, the cleaner can be mixed with any brand of coolant. Idle running not less than 15 minutes, not cleaning vehicles not less than 30 minutes for two years. And then discharge coolant, flush water tank, until out of clear water, suitable for any water cycle system.
2.After cleaning, after waiting for pipeline rehabilitation add fluid to water tank, and inject new coolant and water purification.
How to replace the radiator:
1.Disconnect the battery.
2.Drain the radiator fluid into a suitable container.
3.Remove the old radiator:
-Take off any plastic covers around the radiator.
-Disconnect the electrical connector to the fan, and unbolt and remove the fan assembly.
-Disconnect the radiator hoses from the radiator.
-Disconnect the transmission cooling lines from the bottom of the radiator.
-Remove any clamps, brackets, or screws holding the radiator inside its frame.
-Lift the radiator up and out of the car.
4.Install the new radiator:
-Slide the new radiator into place.
-Connect any clamps or brackets that hold the radiator in place.
-Connect the transmission cooling lines carefully.
-Connect the engine cooling hoses to the radiator.
-Replace the fan and fan shroud.
-Reconnect the fan electrical connection.
-Replace the plastic covers.
5.Fill the radiator with fluid.
6.Check your work to make sure that there are no leaks.
(Tools need to be prepared: Screwdrivers, Wrenches, Drain pan)
Note: Do please keep children and pets away when replacing the operation, the vehicle normal temperature 60 to 80 degrees.
2.Add detergent if the tank is too full can take some brand new radiator
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
