LISTING INCLUDES:1 pc A/C CompressorFIT FOR:2008-2012 Buick Enclave 3.6L2009-2012 Chevrolet Traverse 3.6L2007-2012 GMC Acadia 3.6L2007-2010 Saturn Outlook 3.6LThe Compatibility Is Just For Reference. Please Compare With Your Original One Before Purchasing!ABOUT PRODUCT:Advanced manufacturing technology, high reliability and high performance.Effectively improve the performance and efficiency of the trunk.Standard size, it can be directly replaced.A repair kit that can replace your damaged accessories.Replace Part Number:CO 21625C, 4710705, 157313, 158313, 15926085Attention Please: A/C Compressor Fit for Buick Enclave Traverse GMC Acadia Outlook 157313 158313
LISTING INCLUDES:
1 pc A/C Compressor
FIT FOR:
2008-2012 Buick Enclave 3.6L
2009-2012 Chevrolet Traverse 3.6L
2007-2012 GMC Acadia 3.6L
2007-2010 Saturn Outlook 3.6L
The Compatibility Is Just For Reference. Please Compare With Your Original One Before Purchasing!
ABOUT PRODUCT:
Advanced manufacturing technology, high reliability and high performance.
Effectively improve the performance and efficiency of the trunk.
Standard size, it can be directly replaced.
A repair kit that can replace your damaged accessories.
Replace Part Number:
CO 21625C, 4710705, 157313, 158313, 15926085
Attention Please:
Be sure to clean the air conditioning system before installation, otherwise it will cause compression broken.
1. Remove compressor:
Remove the A/C belt from the A/C compressor pulley. May involve loosening the belt tensioner (if equipped).
2.receiver drier or accumulator, orifice tube or expansion valve.
3.Disconnect the negative battery cable.
4.Remove the bolt that secures refrigerant lines to the A/C compressor. Inspect A/C lines for any contamination such as metal or excessive dirt inside of them. If you find any contamination the system will need to be cleaned.Flush the condenser and evaporator using NON-OIL BASED A/C flush. On expansion valve systems. The valve must be removed before the evaporator can be flushed. Flushed condensers from outlet to inlet and evaporators from inlet to outlet.
5.Drain all the oil from the new compressor ,if you compressor has a drain plug you will need to open it up and drain what oil is in there too.
6.Install half oil charge into the compressor and the remainder throughout the system. Turn compressor shaft 8-10 full revolutions to insure front seal and other internal parts are lubricated.
7.Install new receiver drier or accumulator and new orifice tube or expansion valve.
8.Evacuate the A/C system for a minimum of one hour.
9.After evacuation install half the refrigerant charge and let the system set for 1 minute. This will allow the refrigerant to pick up oil and spread more evenly throughout the system.
10.Turn on the A/C system with the engine running and check to see if cold air is now coming out of the air duct.
11.If the A/C system is functioning ,you may find that your electric radiator fan and compressor clutch will be cycling off and on depending on the outside air temperature.
To confirm that this part fits your vehicle, enter your vehicle's Year, Make, Model, Trim and Engine in the Compatibility Table.
Be sure to clean the air conditioning system before installation, otherwise it will cause compression broken.
1. Remove compressor:
Remove the A/C belt from the A/C compressor pulley. May involve loosening the belt tensioner (if equipped).
2.receiver drier or accumulator, orifice tube or expansion valve.
3.Disconnect the negative battery cable.
4.Remove the bolt that secures refrigerant lines to the A/C compressor. Inspect A/C lines for any contamination such as metal or excessive dirt inside of them. If you find any contamination the system will need to be cleaned.Flush the condenser and evaporator using NON-OIL BASED A/C flush. On expansion valve systems. The valve must be removed before the evaporator can be flushed. Flushed condensers from outlet to inlet and evaporators from inlet to outlet.
5.Drain all the oil from the new compressor ,if you compressor has a drain plug you will need to open it up and drain what oil is in there too.
6.Install half oil charge into the compressor and the remainder throughout the system. Turn compressor shaft 8-10 full revolutions to insure front seal and other internal parts are lubricated.
7.Install new receiver drier or accumulator and new orifice tube or expansion valve.
8.Evacuate the A/C system for a minimum of one hour.
9.After evacuation install half the refrigerant charge and let the system set for 1 minute. This will allow the refrigerant to pick up oil and spread more evenly throughout the system.
10.Turn on the A/C system with the engine running and check to see if cold air is now coming out of the air duct.
11.If the A/C system is functioning ,you may find that your electric radiator fan and compressor clutch will be cycling off and on depending on the outside air temperature.
To confirm that this part fits your vehicle, enter your vehicle's Year, Make, Model, Trim and Engine in the Compatibility Table.
Item SpecificsBrand muparktManufacturer Part Number CE1401252IECManufacturer Warranty 1 YearInterchange Part Number 1521625, 0036, 0143, 296, 10360780, 10360781, 639390, 20844676Other Part Number CO 21625C, 4710705, 157313, 158313, 15926085Superseded Part Number 2 275788, 2021784, 2021784R, 1421625Fitment Type Direct ReplacementCondition NewPlacement on Vehicle FrontType Compressor & Clutch AssemblySuperseded Part Number 1 5512525, 6512525, 7512525, 255659Items Included Fixing NutUniversal Fitment NoMaterial AluminumCalifornia Prop 65 Warning Cancer and Reproductive Harm - www.P65Warnings.ca.govTips Not Manual Instruction IncludedItem Weight 10 lbs
Payment
We accept payment through PayPal, Visa,Discover, Googlepay etc....,Payments must be received within 14 days of sale end.
We process your order within 3business day upon payment(note: NOT counting holidays or weekends).
Shipping
We process and dispatch your purchase within 3business day after payment clearance.
Please contact us if you have special requirements (combination of packaging etc.).
We offer free USPS or FEDEX Package as default.
If you choose express post, we charge a flat rate and we Express Post, which can be delivered in 1-3 business days, depending on your location.
Returns
Please contact us first when return, exchange and refund is required.
Any direct return of purchased items will not be processed.
Change-of-mind return can only be accepted within 7 days after purchase.
All other returns can be accepted in 30 days.
We will closely examine the condition of the returned items and will not issue any refund/exchange before we make sure the items are in their original neat conditions.
Contact Us
Before leaving us neutral or negative response, please contact us first.
We will do everything we can to give you a satisfying solution.
Please don't open case via or PayPal.
Please don't open any return request before contact us.
About Us
We are a professional auto exhaust system accessories seller.We have a strong procurement supply chain, so we have enough ability to provide excellent quality, affordable products.If you have any questions about our products, please contact us in time, our goal is to be 100% satisfied with the buyers.
Shop CategoryStore Home Generic For EV◈Corvette For For Cadillac For & Country For Dodge◈Ram◈Grand For Van◈Mercury For GMC For Jeep◈Cherokee◈Grand For Lincoin For Acura For For Lexus For Mazda For For For Runner◈Sequoia◈Land Cruiser◈Fj Cruiser For Infiniti For Suzuki For Mitsubishi For Volvo For Jaguar For Land Rover For For Porsche For For For For For For Pontiac◈GTO For Scion OtherHot Item Rear Crossmember Subframe Bolt Kit For 07-17 Jeep Compass Patriot Dodge Caliber USD 19.84 100PC 8mm Hole Plastic Rivets Car Clips Fastener Push Clips for Car Auto Fender USD 6.00 Air Suspension Compressor Fit For Mercedes Gl Ml W164 X164 Gl450 Gl550 Pump USD 108.67 For 621 SBC BBC GM 11" Manual Clutch Appllications Bellhousing 1959-1988 Chevy USD 108.28 2PC 25 Ft. 1/4" & 3/16" Copper Brake Line Tubing Kit and 32 Fittings USD 20.67 New List Item 2× Left Right Engine Mount Fit For Mercedes 1662405817/1662405917 W166 X166 C292 USD 56.82 Door Lock Latch Actuator Rear Right For Ford 2012-2017 Focus BE8Z5426412B USD 26.96 1PC 15" Fifth (15th) Wheel For Camper RV Trailer Adapter Hitch to Gooseneck Ball USD 263.08 Engine Oil Pan For Chevy Blazer S10 Jimmy GMC Sonoma Isuzu Olds 4.3L 10220906 USD 76.58 Door Lock Cylinder Cable Left Driver For Honda 2009-2013 Fit 1.5L 72185-TF0-G01 USD 25.65 A/C Compressor Fit for Buick Enclave Traverse GMC Acadia Outlook 157313 158313
LISTING INCLUDES:
1 pc A/C Compressor
FIT FOR:
2008-2012 Buick Enclave 3.6L
2009-2012 Chevrolet Traverse 3.6L
2007-2012 GMC Acadia 3.6L
2007-2010 Saturn Outlook 3.6L
The Compatibility Is Just For Reference. Please Compare With Your Original One Before Purchasing!
ABOUT PRODUCT:
Advanced manufacturing technology, high reliability and high performance.
Effectively improve the performance and efficiency of the trunk.
Standard size, it can be directly replaced.
A repair kit that can replace your damaged accessories.
Replace Part Number:
CO 21625C, 4710705, 157313, 158313, 15926085
Attention Please:
Be sure to clean the air conditioning system before installation, otherwise it will cause compression broken.
1. Remove compressor:
Remove the A/C belt from the A/C compressor pulley. May involve loosening the belt tensioner (if equipped).
2.receiver drier or accumulator, orifice tube or expansion valve.
3.Disconnect the negative battery cable.
4.Remove the bolt that secures refrigerant lines to the A/C compressor. Inspect A/C lines for any contamination such as metal or excessive dirt inside of them. If you find any contamination the system will need to be cleaned.Flush the condenser and evaporator using NON-OIL BASED A/C flush. On expansion valve systems. The valve must be removed before the evaporator can be flushed. Flushed condensers from outlet to inlet and evaporators from inlet to outlet.
5.Drain all the oil from the new compressor ,if you compressor has a drain plug you will need to open it up and drain what oil is in there too.
6.Install half oil charge into the compressor and the remainder throughout the system. Turn compressor shaft 8-10 full revolutions to insure front seal and other internal parts are lubricated.
7.Install new receiver drier or accumulator and new orifice tube or expansion valve.
8.Evacuate the A/C system for a minimum of one hour.
9.After evacuation install half the refrigerant charge and let the system set for 1 minute. This will allow the refrigerant to pick up oil and spread more evenly throughout the system.
10.Turn on the A/C system with the engine running and check to see if cold air is now coming out of the air duct.
11.If the A/C system is functioning ,you may find that your electric radiator fan and compressor clutch will be cycling off and on depending on the outside air temperature.
To confirm that this part fits your vehicle, enter your vehicle's Year, Make, Model, Trim and Engine in the Compatibility Table.
Be sure to clean the air conditioning system before installation, otherwise it will cause compression broken.
1. Remove compressor:
Remove the A/C belt from the A/C compressor pulley. May involve loosening the belt tensioner (if equipped).
2.receiver drier or accumulator, orifice tube or expansion valve.
3.Disconnect the negative battery cable.
4.Remove the bolt that secures refrigerant lines to the A/C compressor. Inspect A/C lines for any contamination such as metal or excessive dirt inside of them. If you find any contamination the system will need to be cleaned.Flush the condenser and evaporator using NON-OIL BASED A/C flush. On expansion valve systems. The valve must be removed before the evaporator can be flushed. Flushed condensers from outlet to inlet and evaporators from inlet to outlet.
5.Drain all the oil from the new compressor ,if you compressor has a drain plug you will need to open it up and drain what oil is in there too.
6.Install half oil charge into the compressor and the remainder throughout the system. Turn compressor shaft 8-10 full revolutions to insure front seal and other internal parts are lubricated.
7.Install new receiver drier or accumulator and new orifice tube or expansion valve.
8.Evacuate the A/C system for a minimum of one hour.
9.After evacuation install half the refrigerant charge and let the system set for 1 minute. This will allow the refrigerant to pick up oil and spread more evenly throughout the system.
10.Turn on the A/C system with the engine running and check to see if cold air is now coming out of the air duct.
11.If the A/C system is functioning ,you may find that your electric radiator fan and compressor clutch will be cycling off and on depending on the outside air temperature.
To confirm that this part fits your vehicle, enter your vehicle's Year, Make, Model, Trim and Engine in the Compatibility Table.
PaymentShippingReturnsContact UsAbout Us
We accept payment through PayPal, Visa,Discover, Googlepay etc....,Payments must be received within 14 days of sale end.
We process your order within 3business day upon payment(note: NOT counting holidays or weekends).
We process and dispatch your purchase within 3business day after payment clearance.
Please contact us if you have special requirements (combination of packaging etc.).
We offer free USPS or FEDEX Package as default.
If you choose express post, we charge a flat rate and we Express Post, which can be delivered in 1-3 business days, depending on your location.
Please contact us first when return, exchange and refund is required.
Any direct return of purchased items will not be processed.
Change-of-mind return can only be accepted within 7 days after purchase.
All other returns can be accepted in 30 days.
We will closely examine the condition of the returned items and will not issue any refund/exchange before we make sure the items are in their original neat conditions.
Before leaving us neutral or negative response, please contact us first.
We will do everything we can to give you a satisfying solution.
Please don't open case via or PayPal.
Please don't open any return request before contact us.
We are a professional auto exhaust system accessories seller.We have a strong procurement supply chain, so we have enough ability to provide excellent quality, affordable products.If you have any questions about our products, please contact us in time, our goal is to be 100% satisfied with the buyers.
All rights reserved.
